Instruction Manual

Rockwell Automation Publication 2100-IN012E-EN-P - February 2012 57
Installing and Removing Plug-in Units Chapter 4
5. Detach the wiring/terminal block from the unit.
6. Place the wiring/terminal block in the vertical wireway to the right of unit.
7. Push the latch mechanism to the left with your right hand.
8. Pull the unit forward (outward) approximately 3 in. (7.62 cm) out of the
MCC.
You may need to reposition your hands as necessary to properly support
the unit while you are removing the unit from the MCC.