Owner manual

92 Rockwell Automation Publication PFLEX-IN029B-EN-P - August 2014

Chapter 3 PowerFlex 700H and 700S Drives - Frame 11 Procedures

Move the Control Frame and Remove the Air Flow Plate and

Protective Covers

You must move the control frame and remove the air flow plate and protective

covers from the drive in order to access fan system components on the drive

power structure. Follow these steps to move the control frame and remove the air

flow plate and protective covers.

1. Review the General Precautions on page 17

2. Remove power from the drive. See Remove Power from the Drive on page

3. If moving the control frame from a DC input drive with pre-charge

interlock, disconnect the wiring from terminal strip X50.

4. Loosen the two hexalobular screws that secure the control frame to the

enclosure and swing the control frame away from the drive.

T20

3.0 N•m (27 lb•in)