Owner manual

44 Rockwell Automation Publication PFLEX-IN029B-EN-P - August 2014

Chapter 1 PowerFlex 700H and 700S Drives - Frame 9 Procedures

1. Review the General Precautions on page 17.

2. Remove power from the drive. See Remove Power from the Drive on page

3. Remove the lower protective cover from the drive. See Remove the Lower

Protective Cover on page 24

4. Remove the lower mounting bolts from the bottom of the frame.

5. Remove the four rubber bushings that cover the mounting screws for the

main fan assembly. Retain these bushings for reuse.

6. Remove the rubber bushing from the hole that covers the main fan motor

power connector at the bottom of the drive.

IMPORTANT

Verify that the upper mounting bolts are secure and properly torqued

so that they will hold the drive to the wall of the system enclosure.