Owner manual

Rockwell Automation Publication PFLEX-IN029B-EN-P - August 2014 29
PowerFlex 700H and 700S Drives - Frame 9 Procedures Chapter 1
Main Fan Fuses (20-PP20202) and Fuse Holder (20-PP20300) Removal
and Installation
The main fan fuses and fuse holder are located on the fan inverter capacitor
bracket below the fan inverter cover.
1. Review the General Precautions on page 17
.
2. Remove power from the drive. See Remove Power from the Drive on page
23
.
3. Remove the lower protective cover from the drive. See Remove the Lower
Protective Cover on page 24
.
4. Remove the main fan inverter capacitor bracket. See Removing the Main
Fan Inverter Capacitor Bracket on page 25
.
5. Remove and replace the fuses, if necessary. See Checking the Fan Inverter
Fuses on page 263
.
6. If, necessary, remove the two M4 x 8 mm POZIDRIV screws that secure
the fuse block to the sheet metal.
7. Install the fuses and fuse block in the reverse order of removal.
PZ2
3.0 N
•m (27 lb•in)
6