Owner manual

Rockwell Automation Publication PFLEX-IN029B-EN-P - August 2014 193

PowerFlex 700AFE Drive - Frame 10 Procedures Chapter 7

Move the Control Frame, and Remove the Screens, Airflow Plate, and Protective Covers (IP21 -

Rittal Enclosure)

You may need to move the control frame based on the mounting location. You

must remove the screens, air flow plate and protective covers from the AFE in

order to access fan system components on the power structure. Follow these steps

to move the control frame and remove the airflow plate and protective covers and

screens.

1. Review the General Precautions on page 17

2. Remove power from the AFE. See Remove Power from the AFE on page

192

3. If moving the control frame from a DC input drive with pre-charge

interlock disconnect the wiring between terminals blocks X9 and X15.

4. If applicable, loosen the two hexalobular screws that secure the control

frame to the AFE enclosure, lift up on the control frame, and swing it out

and away from the power structure.