Owner manual

Rockwell Automation Publication PFLEX-IN029B-EN-P - August 2014 161

PowerFlex 700H and 700S Drives - Frame 13 Procedures Chapter 5

14. Connect the DC- chaining wire set provided in the kit between the DC

power supply and DC- connectors from the DC fan inverter circuit board.

Note the phase markings (U, V, W) on the DC- chaining wire connectors

and verify they are connected to the correct phase.

15. Remove the backing from the drive modification label and attach the label

to the front of a main fan housing.

16. Write “DC fan retrofit” and the installation date on the label.

Inverter section shown