Owner manual

156 Rockwell Automation Publication PFLEX-IN029B-EN-P - August 2014
Chapter 5 PowerFlex 700H and 700S Drives - Frame 13 Procedures
Frame 13 drives can be configured for AC or DC input. A frame 13 AC input
drive has both converter and inverter assemblies, while a frame 13 DC input, or
common bus, drive has only an inverter assembly. Therefore, the procedures for
installing the retrofit kits are detailed in these sections:
• Inverter Units on page 157
• Converter Units on page 162
• Fan Wire Harness Installation on page 165
Follow these steps to remove and replace an existing AC fan system with a new
DC fan system.
SK-H1-DCFANRETROFIT-F14B - For AC input frame 14 drives w/4
NFEs
1 DC fan assembly 10
2 DC fan power supply assembly 1 6
3 DC fan power supply assembly 2 4
4 DC fan power supply wire harness 1 4
5 DC fan power supply wire harness 2 4
6 DC chaining wire harness 2
7 M4 x 8 mm POZIDRIV screws 8
8 M5 x 10 mm hexagonal socket screws 64
9 Wire ties 42
10 Wire tie mounting clamps 4
12 Wire harness for 2 NFE 2
SK-H1-DCFANRETROFIT-CONV - For frame 14 drive converter
extension
1 DC fan assembly 1
2 DC fan power supply assembly 1
3 DC fan power supply wire harness 1 1
4 M4 x 8 mm POZIDRIV screws 2
5 M5 x 10 mm hexagonal socket screws 4
6 Wire ties 6
7 Wire tie mounting clamp 1
9 DC fan power supply wire harness 2 1
Table 3 - Available AC to DC Main Fan Inverter Systems Retrofit Kits (Continued)
Cat. No. Item Description Qty Kit Contents