Manual

Installation Instructions
20P-IN071B-EN-P
PowerFlex
®
DC Drive Resolver Feedback Option Module
What This Kit Includes
Resolver Feedback circuit board
Resolver Interface circuit board
Two stacker connectors
Four 28 mm stand-offs and washers
Three 14 mm stand-offs and washers
Seven screws with captive lock washers
Static strap
Tools That You Need
Phillips® screwdriver (PH2)
Hexalobular screwdriver
Nut driver or wrench
Flathead screwdriver
Phillips® is a registered trademark of Phillips Screw Company.
ATTENTION: Only qualified personnel familiar with DC drives and
associated machinery should plan or implement the installation, start-up
and subsequent maintenance of the system. Failure to comply may result in
personal injury and/or equipment damage.
ATTENTION: To avoid an electric shock hazard, ensure that all power to
the drive has been removed before performing the following.
ATTENTION: This drive contains ESD (Electrostatic Discharge) sensitive
parts and assemblies. Static control precautions are required when
installing, testing, servicing or repairing this assembly. Component damage
may result if ESD control procedures are not followed. If you are not
familiar with static control procedures, reference A-B publication 8000-
4.5.2, “Guarding Against Electrostatic Damage” or any other applicable
ESD protection handbook.
IMPORTANT
The Resolver Feedback option module can only be used with
PowerFlex DC drives with firmware version 5.002 or higher.

Summary of content (18 pages)