Owner's manual

Rockwell Automation Publication 20P-UM001I-EN-P - February 2013 237
Supplemental Drive Information Appendix A
Frame D Overvoltage Clipping Circuit Board Fuses
The following fuses are used to protect the resistors and capacitors on the
Overvoltage Clipping circuit board for frame D drives only.
The Overvoltage
Clipping circuit board is located on the left side wall inside the drive
enclosure, behind the control panel.
Figure 77 - Frame D Overvoltage Clipping Circuit Board Fuse Locations
Circuit Board ID / Revision Designation Fuse (14 x 51 mm)
CFSFxxx / All F11/F21/F31 10 A, 690V fast
Overvoltage Clipping board fuse locations (shown with control panel open).