User Manual

Publication 20P-IN059A-EN-P

3. Remove the bolt and washer that secures each of the U and W phase AC

input terminal bus bars to the rear insulator bar.

4. Remove the two nuts and washers that secure the signal wires to the

terminals on each of the AC current transducers and remove the wires.

5. Loosen the two screws that secure each of the AC current transducers to the

U and W phase terminal bus bar. The current transducers will be loose on

the bus bars.

XF XC

Remove bolt

and washer

Loosen two

screws on CTs

Remove nut, washer

and, signal wires