Manual

Installation Instructions

PowerFlex

DC Drive - Frame C Field Circuit

Fuse Replacement

What This Kit Includes

• Two 10x38mm, 25A 600V fuse

• Two fuse holder caps

What You Need to Do

1. Remove and lock-out all incoming power to the drive.

2. Loosen, but do not remove, the screws that secure the bottom protective

cover to the drive, then slide the cover down and off the drive chassis.

ATTENTION: To avoid an electric shock hazard, ensure that

all power to the drive has been removed before performing the

following.

L1 L2 L3

STS

PORT

MOD

NET A

NET B

Tightening torque:

1.5 N-m (13.3 lb.-in.)

PAGE 1
Installation Instructions PowerFlex® DC Drive - Frame C Field Circuit Fuse Replacement ATTENTION: To avoid an electric shock hazard, ensure that all power to the drive has been removed before performing the following. ! What This Kit Includes • Two 10x38mm, 25A 600V fuse • Two fuse holder caps What You Need to Do 1. Remove and lock-out all incoming power to the drive. L1 L2 L3 I O 2.
PAGE 2
3. On the Control EMI Shield, unscrew the fuse holders and remove the existing fuses from the holders. Unscrew fuse caps and remove fuses Control EMI Shield 4. Insert the new fuses into the holders and replace the fuse holder caps. 5. Install the lower protective cover in the reverse order of removal. 1S7A29 www.rockwellautomation.com Power, Control and Information Solutions Americas: Rockwell Automation, 1201 South Second Street, Milwaukee, WI 53204-2496 USA, Tel: (1) 414.382.2000, Fax: (1) 414.382.