User Manual

6 PowerFlex® DC Drive - Frame C Bimetal Thermostat
4. If present, remove the isolation sheet that is secured to the bus bars.
Important: You must remove the bus bars and SCR modules in order
to easily access and remove the Bimetal Thermostats.
5. Remove the appropriate bus bars in order to access the Bimetal
Thermostats in the drive:
– If removing the SCR modules from a Regenerative drive, refer to
Remove the Bus Bars from a Regenerative Drive
on page 7.
– If removing the SCR modules from a Non-Regenerative drive, refer to
Remove the Bus Bars from a Non-Regenerative Drive
on page 10.
Remove isolation sheet.