User Manual

4 PowerFlex® DC Drive - Frame C Bimetal Thermostat
Important:Mark all connections and wires before removal to avoid
incorrect wiring during reassembly.
4. Disconnect the HIM Communication cable from the connector on the
upper right corner of the Control board and set the cover aside.
Step 3: Remove the
Existing Bimetal Thermostat
You must move the Control EMI shield that holds the Control board in order
to access the Bimetal Thermostats.
1. Carefully disconnect the cables from connectors XFCD and XR on the
Control board.
Pull tabs out
to disconnect
cable.
=
Disconnect
cables