User Manual

PowerFlex® DC Drive - Frame C Bimetal Thermostat 13
3. Remove the four screws that secure each SCR module to the heatsink
and remove the SCR modules. Note the order of the washers on the bolt.
4. Remove the wires connected to the Bimetal Thermostat from connector
X4 on the Pulse Transformer circuit board.
5. Remove the solder from the connections on the two leads of the Bimetal
Thermostat.
6. Remove the Bimetal Thermostat from the heatsink by unscrewing them
at the base.
Remove four screws
Remove solder and
Bimetal Thermostat