User Manual

12 PowerFlex® DC Drive - Frame C Bimetal Thermostat
Remove the SCR Modules and Bimetal Thermostat
1. Remove the remaining bolts, washers and metal plates (for
Regenerative drives only) from the tops of the appropriate SCR
modules. Note the order of the washers on the bolts.
Important: Mark all connections and wires before removal to avoid
incorrect wiring during reassembly.
2. Remove the gate leads that connect the SCR modules to the Pulse
Transformer circuit board from the Pulse Transformer circuit board end.
Remove bolts and metal plates
Note: Regenerative drive shown.
Bolt (32 mm long)
Lock washer
Flat washer
SCR module