Manual

PowerFlex® DC Drive - Frame B Bimetal Thermostat 13
Remove the Bus Bars from a Non-Regenerative Drive
2. Remove the three bolts and washers that secure the U Phase and D
power terminals to the isolation bar.
3. Remove the bolts and washers that secure the wires and bus bars to the
U phase SCR Module and D power terminal and remove the bus bars.
Continue with Remove the Bimetal Thermostat
on page 14.
=
Remove bolts, washers and wires
Non-Regenerative Drive
U Phase Terminal
D Terminal
Non-Regenerative Drive
Remove bolts, washers and wires