Manual

10 PowerFlex® DC Drive - Frame B Bimetal Thermostat
12. Remove the seven screws that secure the board to the stand-offs on the
drive chassis and remove the boards from the drive.
Step 4: Remove the
Existing Bimetal Thermostat
1. Remove the appropriate bus bars in order to access the Bimetal
Thermostat.
– If removing the bus bars from a Regenerative drive, refer to Remove
the Bus Bars from a Regenerative Drive on page 11.
– If removing the bus bars from a Non-Regenerative drive, refer to
Remove the Bus Bars from a Non-Regenerative Drive
on page 13.
Remove screws
Note: Regenerative Drive Shown