Owner manual

4 PowerFlex® DC Drive - Frame B AC Current Transducers
5. Loosen, but do not remove, the screws that secure the top cover to the
drive, then slide the cover up and off the drive chassis.
Important: The HIM assembly is connected via a cable to the Control
board and therefore will not pull free from the drive until
disconnected. See step 4 below for instructions.
Important: Mark all connections and wires before removal to avoid
incorrect wiring during reassembly.
6. Disconnect the HIM Communication cable from the connector on the
upper right corner of the Control board and set the cover aside.
U
V
C
D
W
Tightening torque:
1.5 N•m (13.3 lb•in)
Pull tabs out
to disconnect
cable.