Instruction Manual

12 PowerFlex® DC Drive - Frame A AC Current Transducers for Drives with Bus Bars
Step 5: Remove the
Existing AC Current
Transducers
1. Remove the power connections from terminals U and V at the bottom of
the drive.
2. Remove the screws and washers that secure each of the AC Current
Transducers to the U and V Phase terminal bus bars.
3. Remove the two screws that secure each of the U and V phase terminal
bus bars to the terminal isolation strip at the bottom of the drive.
Remove screws
U Phase bus bar
V Phase bus bar
Note: Regenerative
drive shown
U Phase bus bar V Phase bus bar
Remove screws
Note: Regenerative
drive shown