Instruction Manual
PowerFlex® DC Drive 115V AC to 24V DC I/O Converter Circuit Board 9
Figure 4 I/O Wire Routing
Step 5: Documenting the
Change
1. Record the installation of the 115V AC to 24V DC I/O Converter circuit
board and date of installation on the Field Installed Option label on the
side of the drive (as shown below).
2. Replace the drive covers in the reverse order of removal as described in
Step 2: Opening the Drive on page 3
.
3. Install DPI cable (if present).
Route I/O wiring
between bottom
front cover and
power terminal
cover/shield.
(Frame A shown)
Frame A Shown