Instruction Manual
6 PowerFlex® DC Drive 115V AC to 24V DC I/O Converter Circuit Board
Step 3: Installing the I/O
Converter Board
1. Install and tighten the two (2) spring washers and stand-offs on the
Control board.
Important:Do not over tighten the stand-offs or circuit board damage may
occur.
2. Secure the I/O Converter board to the stand-offs on the Control board
using the two screws provided.
Important:Do not over tighten the screws or circuit board damage may
occur.
Install two spring washers
and stand-offs
Control board
Install two screws