Owner's manual

PowerFlex 700L Frame 1X Drive Installation Instructions – Publication 20L-IN013A-EN-P – June 2009
30
2. Locate and remove Jumper J10 on the Main Control Board (see
Figure 12
).
3. Re-install the Main Control Board into the drive.
4. Wire Enable to “Digital In 6” (see page 26
).
5. Verify that [Digital In6 Sel], Parameter 366 is set to “1” (Enable).
Figure 12 Hardware Enable Jumper Location
=
Main Control
Board Assembly
Jumper J10 on
Main Control Board
Optional
Encoder Board