Owner's manual

4 Rockwell Automation Publication 750-IN006G-MU-P - February 2014
PowerFlex 750-Series EMC Plate and Core(s) – Frames 1…7
1
2…3
4…5
Step Frame Procedure
6
Input Power (R, S, T)
Shielded or Unshielded
to PE Stud
to PE Stud
Motor Cable (U, V, W)
Shielded
1 Loop
(each wire)
T20 or F - 6.4 mm (0.25 in.)
1.8 N•m (16 lb•in)
PE
I/O Shields
IP20,
NEMA/UL Type 0
Flange Mount
Input Power (R, S, T)
Shielded or Unshielded
Motor Cable (U, V, W)
Shielded
to PE Stud
to PE Stud
I/O Signal Shields
I/O Signal Wires
M4 (7 mm) 1.8 N•m (16 lb•in)
PE
Frame 2 Shown
IP20,
NEMA/UL Type 0
Flange Mount
to PE Stud
to PE Stud
Input Power (R, S, T)
Shielded or Unshielded
Motor Cable (U, V, W)
Shielded
M6 (10 mm) 5.6 N•m (50 lb•in)
PE
I/O Signal Shields
I/O Signal Wires
The motor cable ground wire connects to the motor PE stud in the drive, however it should
not
go through the core. Refer to Wiring and Grounding Guidelines for Pulse Width
Modulated (PWM) AC Drives, publication DRIVES-IN001
for further information.
Frame 5 Shown