Instruction Manual

2 Stegmann Feedback Option Board for PowerFlex® 700S Drives
What You Need to Do
To remove the Stegmann Feedback option board from the PowerFlex 700S
drive:
❐Step 1: Remove power from drive
❐Step 2: Remove cover(s) from drive
❐Step 3: Remove control assembly from drive
❐Step 4: Remove feedback option board
To install the new Stegmann Feedback option board on the PowerFlex 700S
drive:
❐Step 5: Install feedback option board
❐Step 6: Install Phase I control assembly
❐Step 7: Wire Stegmann feedback option board to encoder
❐Step 8: Install Phase II control assembly
❐Step 9: Install covers on drive
❐Step 10: Document change
To return a replaced Stegmann Feedback option board to Rockwell
Automation, use the packing material from the new Stegmann Feedback
option board.