Owner's manual

Chapter 1
Installation/Wiring
Chapter Objectives
This chapter provides the information needed to mount and wire the
PowerFlex 700S AC drive for Frames 1 - 6. For installation instructions for
the PowerFlex 700S AC drive for Frames 9 - 12, refer to PFLEX-IN006.
Since most start-up difficulties are the result of incorrect wiring, take every
precaution to assure the wiring is correct. Read and understand all items in
this chapter before beginning installation.
For Information on … See Page...
Opening the Cover
1-2
Mounting Clearances 1-2
AC Supply Source Considerations 1-3
Grounding Requirements 1-4
Fuses and Circuit Breakers 1-5
Power Wiring 1-6
Using Input/Output Contactors 1-15
Disconnecting MOVs and Common Mode Capacitors 1-16
I/O Wiring 1-19
Connecting SynchLink 1-33
CE Conformity 1-35
!
ATTENTION: The following information is merely a guide for
proper installation. Rockwell Automation, Inc. cannot assume
responsibility for the compliance or the noncompliance to any
code, national, local or otherwise for the proper installation of this
drive or associated equipment. A hazard of personal injury and/or
equipment damage exists if codes are ignored during installation.