Instruction Manual

PowerFlex® 700S and 700H Frame 12 DC Bus Connector Kit 27
Publication PFLEX-IN022A-EN-P
2. Secure the right side DC– terminal bus bar to the Z-shaped bus bar that
extends up from the DC– bus bar assembly using a M10x30 bolt, flat and
lock washer and hex nut, as shown below.
Important:.Do not fully tighten this assembly. Final torque must be applied
after all bus bars have been installed.
3. Secure the bus bar to the DC– terminal using a M10x30 bolt, flat and lock
washer and hex nut.
Important:Do not fully tighten this assembly. Final torque must be applied
after all bus bars have been installed.
Note: previously installed parts not shown for clarity only.
Secure to DC-
terminal