Instruction Manual

PowerFlex® 700S and 700H Frame 12 DC Bus Connector Kit 25
Publication PFLEX-IN022A-EN-P
Step 13: Install the Left Side
DC+ Terminal Bus Bar
1. Secure the left side DC+ terminal (non- curved) bus bar to the L-shaped bus
bar mounted through the air flow plate using an M10x30 bolt, flat washer,
lock washer and hex nut as shown below.
Verify that the bus bar is in front of the DC+ terminal on the drive and that
the connection holes align.
Important:.Do not fully tighten this assembly. Final torque must be applied
after all bus bars have been installed.
Note: previously installed parts not
shown for clarity only.
Verify bus bar is in front of DC+
terminal and holes align