Instruction Manual

PowerFlex® 700S and 700H Frame 12 DC Bus Connector Kit 19
Publication PFLEX-IN022A-EN-P
2. Secure the DC– bus bar assembly to the insulated standoff on the left side
mounting rail using a M8x16 bolt and flat and lock washer.
Important:Do not fully tighten this assembly. Final torque must be applied
after all bus bars have been installed.
3. Secure the DC- bus bar to the DC– terminal on the drive using a M10x30
bolt, flat and lock washer and hex nut.
Important:Do not fully tighten this assembly. Final torque must be applied
after all bus bars have been installed.
Top View
Left side
mounting rail
Secure to DC-
terminal