Instruction Manual

Publication PFLEX-IN022A-EN-P
12 PowerFlex® 700S and 700H Frame 12 DC Bus Connector Kit
2. Secure a M10x25 bolt, flat and lock washers and hex nut on the tab for the
auxiliary DC– connection.
3. Secure the smaller bus bar to the insulated standoff on the longest bus bar
using a M10x16 bolt and flat and lock washer, through the center hole in the
smaller bus bar, as shown below.
Important:Do not fully tighten this assembly. Final torque must be applied
after all bus bars have been installed.
Secure through center
hole in smaller bus bar