Owner manual

22 PowerFlex® 700S and 700H Frame 14 Replacement Power Structures
Step 5: Installing the
Product Identification Label
on the New Power
Structures
All frame 14 replacement power structures are shipped from the factory
without a product identification label on the drive. If you are installing the
power structures in a 700S drive, you should label it with the accompanying
PowerFlex 700S label. If you are installing the power structures in a 700H
drive, you should label it with the accompanying PowerFlex 700H label.
Step 6: Starting the Drive
1. Install the protective covers, screens and air flow plate on the drive.
Installation is in the reverse order of removal as indicated in Step 2:
Removing the Old Power Structures
on page 3.
2. Start up the drive. Refer to the Start Up procedures in the appropriate
publication:
– User Manual - PowerFlex 700S Drives with Phase II Control,
20D-UM006
– Programming Manual - PowerFlex 700H Drives, 20C-PM001
DC BUS CONDUCT
ORS AND CAP
A
CITORS
OPERA
TE AT HIGH
VO
L
TAGE. REM
O
VE PO
WER
AND W
AIT 5 MINUTES BEFOR
E SER
VICING
DANGER
!
OR