Owner's manual

6 Rockwell Automation Publication 20D-IN010B-EN-P - November 2010
SynchLink™ Board for PowerFlex® 700S Drives with Phase II Control
5. Loosen the two mounting screws on the front of the control assembly and
slide the control cassette off the mounting bracket.
Step 4: Remove the Inside
Cover from the Control
Cassette
• Loosen the three screws on the face of the front cover and remove the
cover.
Frame 9 shown
=
Proper tightening torque for reassembly
is 0.8… 1.1 N•m (7…10 lb•in)
Loosen three screws and remove cover
=