Owner manual

Rockwell Automation Publication 20B-IN028B-EN-P - August 2014 7
Replacing a Balancing Resistor on a PowerFlex 700 Drive, Frames 8, 9, and 10
Replacing the DC+ Bus Bar
with a Balancing Resistor
Follow these steps to replace the DC+ bus bar with a single balancing resistor on
frame 8, 9, or 10 PowerFlex 700 drive.
Note that the replacement part contains both the DC+ bus bar and new
balancing resistors (as shown in the following image).
1. Unpack the replacement assembly.