Owner manual

Rockwell Automation Publication 20B-IN028B-EN-P - August 2014 13
Replacing a Balancing Resistor on a PowerFlex 700 Drive, Frames 8, 9, and 10
8. Follow steps a…c to install the replacement bus bar and resistor assembly
into the drive.
a. Install the set screws and nuts removed in step 7
c on page 12. Tighten
the nuts to 5.65 N•m (50 lb•in).
b. Install the bolts removed in step 7
b on page 12. Tighten the bolts to
23.5 N•m (208 lb•in).
c. Install the bolts removed in step 7
a on page 11. Tighten the bolts to
23.5 N•m (208 lb•in).
Frame 8 Drive Shown