Owner manual

Rockwell Automation Publication 20B-IN026B-EN-P - July 2013 77
Converter Assembly Component Replacement Procedures Chapter 4
Precharge Board
See Chapter 1 - Component Diagrams and Torque Specifications to locate
components in these instructions.
Remove Components
1. Read and follow the Safety Precautions on page 11 and Important Initial
Steps on page 12.
2. Remove safety shields and enclosure covers as needed.
3. Carefully label and disconnect all wiring plugs from the Precharge Board.
4. Remove the Precharge Board mounting torx screw (1) located at the lower
left corner of the Precharge Board.
5. Use your fingers or needle-nose pliers to squeeze the tabs of each of the
three spacers and separate the Precharge Board from the mounting plate.
6. Remove the Precharge Board; return or dispose of it properly.
Spacers (3)Mounting Screw (1)
J3J1 J2