Owner manual

30 Rockwell Automation Publication 20B-IN026B-EN-P - July 2013
Chapter 2 Basic Component Removal Procedures
15. Remove the Transitional Busbar assembly.
IMPORTANT
Set screws may come out with the nuts. Save all nuts and set screws.
Upper Capbus Support Nuts (18)
attached to Set Screws
Side Standoffs and Brackets (6)
DC Choke Output Cables
Balancing Resistor
Note: Photo shows set screws in
Capacitors; these set screws may come out with
the Transitional Busbar assembly nuts when they
are removed.
Lower Capbus Support Nuts (8)
attached to Set Screws
Upper and Lower Capbus Support
Connecting Brackets