Owner manual

26 Rockwell Automation Publication 20B-IN026B-EN-P - July 2013
Chapter 2 Basic Component Removal Procedures
9. Remove the six nuts for mounting the Stacking Panel.
10. Remove Stacking Panel and carefully set aside.
Install Components
1. Reinstall the Stacking Panel components in the reverse order of removal.
2. Torque mounting nuts to 5.6 N•m (50 lb•in).
3. Replace all wiring to TB9.
4. Replace the black Thermal Sensor Wire to J6 on the Power Interface
Board.
5. Replace the red and black wires from TB2 on the DC Bus Filter Board.
6. Replace all safety shields and enclosure covers before applying power to the
drive.
Mounting Nuts (6)