Manual

Rockwell Automation Publication 20B-IN024C-EN-P - June 2012 65
Component Replacement Procedures Chapter 3
6. Disconnect the U, V, and W busbars at the top of each bar where they
connect to the output busbars for the current transducers with two 17 mm
bolts and one 11 mm nut.
Do not remove the busbars from the setscrew on the output busbars at this
time.
Do not disconnect the U, V, or W busbars at the bottom.
7. Remove the four 10 mm nuts for the busbars mounting plate.
Setscrew after 11 mm
nut is removed
Output Busbar
17 mm bolts
11 mm nut
Current Transducer
Busbar Mounting
Plate
10 mm nuts (4)