Manual

Rockwell Automation Publication 20B-IN024C-EN-P - June 2012 27
Basic Component Removal Procedures Chapter 2
4. Remove the six nuts for mounting the stacking panel.
5. Remove the stacking panel; carefully set aside.
Install Components
1. Torque the six mounting nuts to 5.6 N•m (50 lb•in).
2. Connect the main control panel thermal sensor and wire located above the
main control board.
3. Connect all wiring that was removed.
4. Replace all safety shields and enclosure covers before applying power to the
drive.
Mounting
Nuts (6)
Shown without main control panel.
NOTE: Mounting position of boards on stacking panel may vary.