Manual

Rockwell Automation Publication 20B-IN024C-EN-P - June 2012 25
Basic Component Removal Procedures Chapter 2
Install Components
1. Replace any customer wiring to TB11.
2. Connect the wire harnesses from TB11 to the switch mode power supply
board ( J4 connector) and at TB1 and TB2 on the power interface board.
3. Torque the two mounting nuts at the top of the main control panel to
5.6 N•m (50 lb•in).
4. Torque the two screws on the main control panel below TB11 to 2.9 N•m
(26 lb•in).
5. Connect the incoming ground wire to TB11.
6. Connect the ribbon cable going from the main control board (J2) to the
power interface board (J1).
7. Replace all safety shields and enclosure covers before applying power to the
drive.