Manual

20 Rockwell Automation Publication 20B-IN024C-EN-P - June 2012

Chapter 1 Component Diagrams and Torque Specifications

Fastener Torque

Specifications

Torque Sequence

The following illustrates initial and final tightening sequences for components

fastened to a heatsink using two, four, and six screws. Initial torque is 1/3 (33%)

of final torque, except six-point mountings, which require 0.7 N•m (6 lb•in.) The

numeric illustration labels are for your assistance. Drive components do not carry

these labels.

Figure 6 - Various-point Mounting

ATTENTION: When mounting components to a drive’s heatsink,

component fastener torque sequences and tolerances are crucial

to component-to-heatsink heat dissipation.

Components can be damaged if initial tightening procedure is not

performed to specification.

Initial

Torque Sequence

Final

Torque Sequence

Two-Point Mounting

Start

End

End Start

1212

Initial

Torque Sequence

Final

Torque Sequence

Four-Point Mounting

End

Start

End

1243

3 421

Note: Do not exceed 0.7 N•m (6 lb•in) on initial torque.

Initial Torque Sequence

Six-Point Mounting

Start

End

Final Torque Sequence

Start

End

3 1