User Manual

52 Rockwell Automation Publication 20B-UM002G-EN-P - July 2014
Chapter 1 Programming and Parameters
UTILITY
Faults
238 [Fault Config 1]
Enables/disables annunciation of the listed faults.
240 [Fault Clear]
Resets a fault and clears the fault queue.
Default:
Options:
0
0
1
2
“Ready”
“Ready”
“Clear Faults”
“Clr Flt Que”
241 [Fault Clear Mode]
Enables/disables a fault reset (clear faults)
attempt from any source. This does not apply to
fault codes which are cleared indirectly via other
actions.
Default:
Options:
1
0
1
“Enabled”
“Disabled”
“Enabled”
242 [Power Up Marker]
Elapsed hours since initial drive power up. This
value will rollover to 0 after the drive has been
powered on for more than the max value shown.
For relevance to most recent power up see [Fault
x Time].
Default:
Min/Max:
Units:
Read Only
0.0000/214748.3647 Hr
0.1 Hr
244
246
248
250
252
254
256
258
243
245
247
249
251
253
255
257
[Fault 1 Code]
[Fault 2 Code]
[Fault 3 Code]
[Fault 4 Code]
[Fault 5 Code]
[Fault 6 Code]
[Fault 7 Code]
[Fault 8 Code]
A code that represents the fault that tripped the
drive. The codes will appear in these parameters
in the order they occur ([Fault 1 Code] = the most
recent fault).
Default:
Min/Max:
Units:
Read Only
0/65535
0
File Group No.
Parameter Name & Description
See page 16 for symbol descriptions
Values
Related
1110001000x000xx
10 01234567891112131415
1 = Enabled
0 = Disabled
x = Reserved
Bit #
Factory Default Bit Values
Power Loss
UnderVoltage
HS Low Temp
(3)
Motor OverLd
Shear Pin
AutRst Tries
Decel Inhibt
Motor Therm
In PhaseLoss
(1)
Load Loss
ShearPNo Acc
(2)
Out PhaseLoss
(4)
PTC HW
(1)
Default is “1” for Frames 8-10.
(2)
When enabled, the drive ignores the
shear pin fault during any accel/decel.
(3)
Firmware 6.002 and later.
(4)
If Torque Prove is enabled, Output
Phase Loss will always be performed.
(5)
Firmware 9.001 and later.
When these faults are disabled,
always change parameter 173
[DPI Loss Action] to a value of
“1” or “2.”
11x 1xxxxxxxxxxxx
26 161718192021222324252728293031
1 = Enabled
0 = Disabled
x = Reserved
Bit #
DPI P1 Loss
(5)
DPI P2 Loss
(5)
DPI P3 Loss
(5)