Owner's manual

Publication 2099-IN002B-EN-P — October 2008

Kinetix 7000 DC-DC Converter and Control Board Kits 9

Refer to Remove the Drive Covers on page 4 and reverse the order of

steps for your drive module.

8. Return the drive to operation.

Install the Control Board Kit

Follow these steps to remove and replace the control board.

1. Label and remov

e the safe-off (SO), general purpose I/O (GPIO),

general purpose relay (GPR), and ribbon cable connectors from the

control board.

Also, label and remove the fiber-optic (Tx and Rx) connectors, if not

removed earlier.

2. Remove the six connector stand-offs by using a 3/16 in. thin-walled

socket or nut driver.

3. Remove the two connector plate screws by using a small Phillips

screwdriver.

IMPORTANT

When replacing the top cover, temporarily remove the

fiber-optic cables from the drive Tx and Rx connectors. This

allows the top cover to seat properly with the chassis.

Kinetix 7000 Drive

(2099-BM07-S is shown)

Ribbon Cable

Connector

Control Board

Screws

Control Board

Connector Plate

Screws, 2x

Connector Plate

Stand-offs, 2x

Connector Stand-offs, 6x

SO, GPIO, GPR, and

Fiber-optic Connectors

Display Board

IMPORTANT

Thin-walled socket or open-ended wrench is required to

remove the screws due to the clearance between screw

and connector.