Owner's manual

Publication 2098-RM001C-EN-P – August 2002
Programming Reference 2-55
25 Set Reset I Peaks USINT 1 Resets the peak value parameters to zero: Peak
Positive Position Error (Peak +Posn Error), Peak
Negative Position Error (Peak -Posn Error), Positive
Peak Current, and Negative Peak current.
0 - No Action (default)
1 - Reset
26 Set Define Home
Command
USINT 1 Causes the present motor position to be selected as
Home position. The position command is set to the
Home Position value, and the position feedback is
simultaneously set to its appropriate value,
according to the position error.
0 - No Action (default)
1 - Execute Command
27 Set Host Enable USINT 1 Sets or returns the drive’s Host Enable flag. If set to
'Enable' and the ENABLE input is active, the drive is
enabled. If set to 'Disable' or the ENABLE input is not
active, the drive is disabled. By default, Host Enable
is enabled. If the drive is reset or power cycled, the
'Host Enable' is automatically set to 'ENABLE'.
0 - Disable
1 - Enable (default)
ATTENTION
!
The Host Enable parameter allows you to temporarily disable the drive. Do not assume that the drive is
permanently disabled via the Host Enable parameter. Failure to comply may result in personal injury
and/or equipment damage.
28 Set Host Control
Mode
USINT 1 Temporarily puts the drive into various tuning and
special operating modes.
0 - Normal Mode (default)
1 - Setpoint Velocity
2 - Setpoint Current
3 - Host Index Mode (Indexing Only)
4 - Autotuning
5 - Step Velocity
6 - Step Position
29 Set Velocity Setpoint DINT 4 Cnts /
Sec
The velocity command value used when the Host
Contrl Mode is 'Setpoint Velocity'. The drive will
ramp up, or ramp down, to the Velocity Setpoint at
the rate of acceleration set by Parameter 31 -
Setpoint Accel. The Velocity Setpoint is not saved in
nonvolatile memory.
Range: -0x7fffffff to 0x7fffffff
Default: 0
30 Set Current Setpoint INT 2 Amps /
128
The current command value used when Parameter
28 - Host Control Mode is set to 2 - Setpoint Current.
The current setpoint is not saved in nonvolatile
memory.
Range: -32767 to 32767
Default: 0
Parameter Object,
Instances ID = 1- 996
Parameter
Instance
Access
Rule
Parameter
Name
Data
Type
Data Size
(Bytes)
Units /
Scale
Description