Owner's manual

Publication 2098-RM001C-EN-P – August 2002
2 Index
DWORD 2-5
EPATH 2-5
INT 2-5
SHORT_STRING 2-5
SINT 2-5
UDINT 2-5
UINT 2-5
USINT 2-5
WORD 2-5
definitions
attribute
2-1
instance 2-1
object 2-1
service 2-1
DeviceNet
node objects
2-4
object 2-9
parameter object 2-45
DeviceNet object 2-2
DeviceNet object class
instance ID = 0 2-9
DINT 2-5
drive configuration 2-45
DWORD 2-5
E
electronic data sheet (EDS) 2-2
end of sequence 2-37
EPATH 2-5
explicit messaging 2-43
nonvolatile memory restrictions 2-43
F
fault
device state conflict
2-45
update failure 2-41
fault configured input 2-42
feedback data pointer 2-23
H
handshake bit 2-23
handshake echo bit 2-41
help, see technical assistance
I
I/O messaging 2-11
identity object 2-2, 2-5
instance
addressing
2-4
definition 2-1
INT 2-5
L
logic commands
abort homing 2-20
abort index 2-19
define home 2-22
define position 2-21
disable serial communications 2-19
enable 2-23
follower enable 2-21
integrator inhibit 2-21
operation mode override 2-21
pause homing 2-20
pause index 2-19
position strobe 2-21
preset select 2-20
remove offset 2-22
reset drive 2-22
reset faults 2-23
start homing 2-22
start index 2-22
logic status
at home
2-37
at index 0 position 2-38
at index 1 position 2-39
axis homed 2-37
brake active 2-40
dc bus charged 2-40
drive enabled 2-40
drive ready 2-40
end of sequence 2-37
fault disable 2-40
in dwell 2-37
in motion 2-37
in position 2-39
negative current limit 2-40
negative hardware overtravel 2-38
negative software overtravel 2-38
position limit 1 2-39
position limit 2 2-39
positive current limit 2-40
positive hardware overtravel 2-38
positive software overtravel 2-38
registered 2-37
startup commutation done 2-38
tracking 2-38
up to speed 2-40