User Manual Owner manual

149 Publication 2093-UM001A-EN-P — March 2007

Chapter

Removing and Replacing the Kinetix 2000

Drive Modules

Introduction

This chapter provides remove and replace procedures for your Kinetix 2000

system components.

Before You Begin

You will need the following tools available before you begin removal and

replacement procedures:

• A flat-blade screwdriver

• A small flat-blade screwdriver, 3.5 mm (0.14 in.)

• Voltmeter

Topic Page

Before You Begin 149

Remove Modules from the Power Rail 150

Replace Modules on the Power Rail 151

Remove the Power Rail 151

Replace the Power Rail 152

ATTENTION

This drive contains ESD (Electrostatic Discharge) sensitive parts and

assemblies. You are required to follow static control precautions when

you install, test, service, or repair this assembly. If you do not follow

ESD control procedures, components can be damaged.

If you are not familiar with static control procedures, refer to

Allen-Bradley publication 8000-4.5.2, Guarding Against Electrostatic

Damage, or any other applicable ESD Protection Handbook.