Owner manual

Rockwell Automation Publication 20HIM-UM001D-EN-P - February 2013 61
Using the HIM Chapter 4
Resolving ‘Changed’ or ‘Requires Configuration’ Conflicts
When a ‘Changed’ or ‘Requires Configuration’ conflict exists on powerup, a ‘!’
symbol precedes the port number in the Device Conflicts pop-up box.
1. Select a port device (in this example, the Encoder card) and press either
the INFO soft key to show additional information about the conflict, or
press the FIX soft key to resolve all device conflicts.
Resolving ‘Not Functioning’, ‘Not Supported’, or ‘Invalid Duplicate’
Conflicts
When a ‘Not Functioning’, ‘Not Supported’, or Invalid Duplicate’ conflict exists
on powerup, an ‘X’ symbol precedes the port number in the Device Conflicts
pop-up box.
1. Select the port preceded with an ‘X’ (in this example, Port 05) and press
the INFO soft key to show additional information about the conflict (see
example below).
2. Press the ENTER soft key to
affirm and re-display the
Device Conflicts pop-up box.
Press the ENTER soft key to affirm
and resolve all device conflicts, or
press the ESC soft key to cancel.
Stopped
0.00 Hz
AUTO
Device Conflicts:
! Port 05: I/O Module 24 V
! Port 06: Device Not Found
FIX
F
INFO
! Port 04: Encoder
Stopped
0.00 Hz
AUTO
! 04: Encoder
Changed
Prev: I/O Module 24 V
F
Example screen when the INFO
soft key is pressed.
ENTER
Stopped
0.00 Hz
AUTO
About to permanently
erase the previous
device(s) configuration
Continue?
F
Example screen when the FIX
soft key is pressed.
ESC
ENTER
Stopped
0.00 Hz
AUTO
F
INFO
Device Conflicts:
! Port 04: Encoder
! Port 06: Device Not Found
X Port 05: Not Functioning