User Manual

B-4 Adapter Parameters
20-COMM-C/Q ControlNet Adapter User Manual
Publication 20COMM-UM003F-EN-P
25 [M-S Input]
Sets the Master-Slave input data. This data is
produced by the scanner and consumed by the
adapter.
Default: xxx0 0001
Bit Values: 0 = I/O Disabled
1 = I/O Enabled
Type: Read/Write
Reset Required: Yes
26 [M-S Output]
Sets the Master-Slave output data. This data is
produced by the adapter and consumed by the
Master device (for example, scanner).
Default: xxx0 0001
Bit Values: 0 = I/O Disabled
1 = I/O Enabled
Type: Read/Write
Reset Required: Yes
27 [Ref Adjust]
Sets the percent scale factor for the Reference
received from the network.
Default: 100.00%
Minimum: 0.00%
Maximum: 200.00%
Type: Read/Write
Reset Required: No
Parameter
No. Name and Description Details
Bit
Definition
Not Used Not Used Not Used Datalink D Input Datalink C Input Datalink B Input Datalink A Input Cmd/Ref
Default x x x 0 0 0 0 1
Bit 76543210
Bit
Definition
Not Used Not Used Not Used Datalink D Output Datalink C Output Datalink B Output Datalink A Output Cmd/Ref
Default x x x 0 0 0 0 1
Bit 76543210
!
ATTENTION: To guard against equipment damage and/or personal injury, note
that changes to Parameter 27 - [Ref Adjust] take effect immediately. A drive
receiving its Reference from the adapter will receive the newly scaled
Reference, resulting in a change of speed.