Instruction Manual

Installing the Adapter 2-3
20-COMM-D DeviceNet Adapter User Manual
Publication 20COMM-UM002G-EN-P
Setting the Data Rate Switch
Set the adapter Data Rate switch (Figure 2.2) by rotating the switch to the
desired setting.
Figure 2.2 Setting Adapter Data Rate Switch
The Data Rate switch setting can be verified by viewing Parameter 06 -
[DN Rate Act] or Diagnostic Device Item number 29 (page 7-5
) with any
of the following drive configuration tools:
• PowerFlex HIM
• Connected Components Workbench software, version 1.02 or later
• DriveExplorer software, version 2.01 or later
• DriveExecutive software, version 3.01 or later
Setting Description
Auto Sets the adapter to the data rate used by other network devices. Another
device on the network must be set to a data rate.
125K, 250K, 500K Sets the adapter to the respective data rate.
PGM (default) The adapter uses the value stored in Parameter 05 - [DN Rate Cfg] for the
data rate. See Setting the Data Rate
on page 3-3. Also, the adapter uses the
value stored in Parameter 03 - [DN Addr Cfg] for the node address. See
Setting the Node Address on page 3-3.
125K
250K
500K
PGM
AUTO