User Manual

4-11 Programming
Publication 198-UM001B-EN-P September 2001
In the above screen highlight the driver you have configured. Go to &RPPXQLFDWLRQ and
select 56:KR. This will allow RSLinx to browse the network and refresh the screen with all
devices found, an example of which follows:
Now that you have configured a driver, you can launch RSLogix 500 to begin programming.
In RSLogix you will be able to write explicit messages in SLC ladder logic. You will also be
able to monitor our input and output bits.
To begin, click “new” under the file menu. You will be prompted to select the type of
processor that you would like to use. Select the appropriate processor and click 2..