Owner's manual

Assembly of Reversing Starters

321

Assemble the reversing contactor:

• Turn the coil terminals to the load side according

the contactors instruction sheet.

• Place the mechanical interlock between contactors

• Insert the dovetail connector from rear side

• Attach the reversing connection on load side

• Attach the parallel connection and the Eco

connection module on line side

The enclosure ts for both,

the 140M-C and the 140M-D

MPCB.

For the 140M-D, shorten the

support by breaking o the

2 tabs.

Snap the 800F contact blocks

Prepare the MPCB by replacing the knob and

adding the auxiliary:

• Remove original knob

• Remove front cover

• Add auxiliary and lockable twist knob

onto the device support:

• Pos. 2 (center): N.C. contact

• Pos. 3 (left): N.O. contact

Do the control wiring according

the wiring diagram/wire table.

Snap the reversing contactor

onto the metal hat rail

(2)